2 or to Friendly name and press the Menu Select button directly below Edit.
A blinking cursor appears in the Friendly Name screen.
3 Use the keypad to edit the text.
4 Perform one of the following actions:
• Press the Menu Select button directly below Ok to save the new Friendly Name and return to
the Bluetooth feature screen.
7.25.5
Pairing with LEX Handheld
Prerequisites: Ensure that Bluetooth feature of your radio is on and the Bluetooth tones are enabled.
Procedure:
1 Turn on the handheld and activate the Bluetooth feature.
2 Place the handheld close to the radio aligning the Bluetooth Pairing Location on the handheld
with the Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an incremental-pitched tone from the radio. The
radio begins to connect to the handheld. If the connecting process is successful, you hear an
incremental-pitched tone. The display shows <Device Friendly Name> connected, and
the Bluetooth icon turns from
to .
If unsuccessful, one of the following scenarios occur:
• You hear a short, low-pitched tone and the display shows Bluetooth pairing failed (if
pairing fails).
• You hear a decremental-pitched tone and the display shows <Device Friendly Name>
unpaired (if the connection fails within 6 seconds).
• You hear a short, low-pitched tone and the display shows <Device Friendly Name>
connect failed (if the radio has the pairing record of the handheld and the connection
fails).
Repeat this step to re-initiate the pairing process.
NOTE: To unpair the handheld after a successful connection, follow the steps in Viewing
and Clearing the Bluetooth Device Information on page 119.
7.25.6
Responder Alert Sensors
Responder alert sensors allow the radio to send an over-the-air (OTA) notification when the radio
receives the holster, weapon fired, and vest pierced sensor events.
To enable the feature, ensure that the Global Positioning System (GPS), Enhanced Data, and
Bluetooth feature of your radio is turned on and the radio supports Bluetooth Low Energy (BTLE).
You can disable the feature temporarily or permanently. This feature allows you to prevent one or all
events from being reported OTA.
MN001425A01-AW
Chapter 7 : Advanced Features
120
To Next Page
Loading...
Need help?
General
