• or to [Other Recpnt] and press the Menu Select button below Edit. When a
blinking cursor appears on the Enter Address screen. Use the keypad to type the address
entry. Proceed to step 9 to send the message.
9 Press the Menu Select button directly below Send or press the PTT button to send the
message.
The display shows the Send Message screen and Sending msg.
If the message is sent, you hear a tone and the display shows Msg sent.
If the message is not sent, you hear a low tone, the display shows Send failed and returns to
the main TMS screen.
NOTE: You can append a priority status and/or a request reply to your message.
See Priority Status and Request Reply for New Text Messages on page 87 for more
information.
7.16.4
Priority Status and Request Reply for New Text Messages
This feature only supports Model 3.5 and Model 2.5.
Before sending your message, you can add a priority status, request reply, or both to your message.
7.16.4.1
Appending a Priority Status to a Text Message
Prerequisites: Ensure that an outgoing message is composed to allow you to perform this procedure.
See Composing and Sending a New Text Message on page 85 for more information.
When and where to use:
NOTE: The Priority Status icon on a message does not imply that the message gets higher
priority over the other messages when it is being transmitted. It is just an indication that can be
embedded into a message to let the receiver know that the message is important.
Procedure:
1 Press the Menu Select button directly below Optn .
2
or to Mark Important and press the Menu Select button directly below Sel to indicate
that the message is important.
The priority status icon appears beside the normal message icon on the label bar.
7.16.4.2
Removing a Priority Status from a Text Message
Prerequisites: Ensure there is an outgoing message composed to allow you to perform this
procedure. See Composing and Sending a New Text Message on page 85 for more information.
Procedure:
1 Press the Menu Select button directly below Optn .
2
or to Mark as Normal and press the Menu Select button directly below Sel to remove
the priority status from the message.
The display shows the normal message icon on the label bar.
MN001425A01-AW
Chapter 7 : Advanced Features
87
To Next Page
Loading...
Need help?
General
