56
Dialling on Receiving a Call
If you dial and a call is incoming, the MTM800 stays in
current mode and the display remains unchanged while you
hear the call. Dialling continues on current display.
Making a Private PPC (Pre-emptive Priority Call)
1. Enter the private number and press PTT
or .
2. If the display shows the called user is
busy, press
Yes to interrupt the on-going
call.
3. You will hear a ringing tone. Wait for the called person to
answer your call.
4. Continue the call as in a regular half-duplex or full-duplex
Private Call.
Call Queuing
When there are no available infrastructure resources for a
call while in a setup phase, or while in an active call during
cell re-selection, the call will be queued. The MTM800 will
remain in queue for a pre-programmed period of time. If the
resources become available, the call will proceed. If there are
no resources after a certain period of time, the MTM800 will
end the call.
When an Emergency Call is received, then dialling is aborted,
the MTM800 switches to the group mode and Emgcy In Use
display appears.
This feature is only available if set up by your Service Provider.
Yes
Party busy
Interrupt?
No
6815321H01_KOR.book Page 56 Thursday, November 13, 2008 8:06 AM
To Next Page
Loading...
Need help?
General