MTS Systems FlexTest GT User Manual

MTS 793 Controller Hardware
FlexTest GT Controller Connections
104
Analog inputs The analog-to-digital mezzanine cards
accommodate up to six analog input
signals. Each A/D input signal must be
within ±10 volts.
• Use pin 3 or 6 to prevent problems
with floating grounds between devices.
• Analog inputs can be connected at the
BNC connectors of a Model 493.75
Analog In transition module and the
outputs from this module are
connected to the Model 493.40 I/O
Carrier module.
• Analog inputs can be connected at the
BNC connectors of a Model 493.77
Filtered Analog Input transition module
and the outputs from this module are
connected to the Model 493.40 I/O
Carrier module.
493.77 filter modules The following filter modules are available for board mounting at the
BNC connectors of a Model 493.77 Filtered Analog Input transition
module:
+
-
+
-
+
-
Input 1
Analog
Ground
Input 2
Analog
Ground
Input 3
Input 4
Input 5
Input 6
+
-
+
-
+
-
+
-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
J4 - J7
To
A/D
From
A/D
Filter Module Specifications
ASSEMBLY NUMBER HZ TYPE
047-774-401 50 Bessel
047-774-402 100 Bessel
047-774-403 200 Bessel
047-774-404 500 Bessel
047-774-405 1000 Bessel
047-774-406 2000 Bessel
047-774-407 5000 Bessel
047-774-408 120 Bessel
047-774-409 300 Bessel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

MTS Systems FlexTest GT Specifications

General

Brand	MTS Systems
Model	FlexTest GT
Category	Controller
Language	English