To Next Page

To Previous Page

MTS 793 Controller Hardware

200

Multiple Controller Connections

About multiple

Controller networks

Some characteristics of a multiple Controller network are as follows:

• Each Controller in the network provides control for one station

with up to two channels.

• A hub connects each Controller in the network to the supervising

PC.

• A single network may have a maximum of four stations

(regardless of the number of Controllers cabled to the hub).

• When used in a network, Controllers must be registered for

automation and operate in the automation mode.

• Each Controller in the network must have a unique ID and name.

For more information about setting up multiple controller networks for

FlexTest SE Controllers, see Appendix D, Using Multiple Automated

Controllers in the FlexTest SE User’s Manual.

Typical multiple controller cabling

HUB

011-437-8xx 011-437-8xx

011-437-8xx

MVME

2100

493.40

I/O

CARRIER

493.42

SYSTEM

I/O

MOTOROLA

J28 HSM

J25 Hpu E-stop J29

J49 Aux Pwr

Intlk J43

J54 Dig In

Dig Out J55

J51 Box In

Box Out J52

Analog In

Analog out

SHUNT CAL

J4 I/O

J5 I/O

J6 I/O

J7 I/O

TYPE E PC-MIP

RUN 6TS BFL

ABT RST

DEBUG

PCI MEZZANNE CARD

Power

100240 VAC

5060 Hz, 126A

AIR

FLOW