Nokia 7368 User Manual

Configure a G-240W-G indoor ONT
154
7368 ISAM ONT G-240W-G Product Guide
3FE-47555-AAAA-TCZZA Issue: 01
2 Configure the test times if desired.
3 Click Refresh to update the data.
4 STOP. This procedure is complete.
7.3 SFU mode configuration
HGU is the default mode for the G-240W-G ONT, but you can use SFU mode to view
device status information, change the password, authenticate the LOID, and change
the SLID.
7.3.1 Switch from default HGU mode to SFU mode
To switch from the default HGU mode to using SFU mode, use the procedure below.
Procedure 55 Switching to SFU mode
1 Power up the G-240W-G ONT.
2 Change the Operator ID (OPID) to XXXX to enable the ONT to switch to SFU mode, as
described in “Modifying the operator ID”.
3 Reboot the ONT.
4 STOP. This procedure is complete.
Latency This test is used to determine the lowest round-trip time in milliseconds by
pinging the target server multiple times
Click Latency Test to specify the time for the test
The default is weekly, performed at idle to a public server
DNS Response Time This test is used to determine the lowest round-trip time in milliseconds by
sending a request to the target DNS server
Click DNS Response Test to specify the time for the test
The default is weekly, performed at idle to a public server
Field Description
(2 of 2)
Release 05.08.01a | August 2018 | Edition 01

Nokia 7368 Specifications

General

Brand	Nokia
Model	7368
Category	Network Hardware
Language	English