Beacon G6 unit data sheet
Beacon G6 software and installation feature support
5.3.4 TR-157 support
The Beacon G6 can support LXC container for third party software components on this devices with
minimal 512 M memory. These software components are managed by ACS with the parameters
defined in TR-157.
The TR-157 objects are:
• Mange each software component via SoftwareModules.DeploymentUnit.{i}
• Set software component execution environment via SoftwareModules.ExecEnv.{i}
• Run software component and get the execution status via SoftwareModules.ExecutionUnit.{i}
Note: The device reserves and limits to 64 MB RAM and 32 MB flash in total for all of the third
party applications. The maximum CPU load created or provided to the third party application is
limited to approximately 30%. Underlying non-priority processes may still use the remaining
memory on a temporary basis.
Nokia can assist to review specific applications, taking into account the actual memory load of
the current hardware, current and projected software evolution over time, and the projected
use by a third party application of the software.
5.4 Beacon G6 software and installation feature support
For information on installing or replacing the Beacon G6 see Chapter 6, “Install or replace a
Beacon G6”
5.5 Beacon G6 interfaces and interface capacity
Table 5-4, “Beacon G6 indoor interface connection capacity” (p. 43) describes the supported
interfaces and interface capacity for Beacon G6 .
Table 5-4 Beacon G6 indoor interface connection capacity
Notes:
1. The Beacon G6 provide Wi-Fi service that is enabled and disabled using a Wi-Fi on/off switch.
5.5.1 Beacon G6 connections and components
The following figure shows the physical connections for Beacon G6 .
Use subject to agreed restrictions on disclosure and use.
3FE-49949-AAAA-TCZZA 43
To Next Page
Loading...
Need help?
General
