44952001TH Rev.2
4-25
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
(7) Remove the screw (black-colored, L=8mm) to remove the Plate-USB .
And remove two screws (silver-colored, L=12mm) to remove the cord-USB .
And remove the core
from Cord-USB . (two claws)
(8) Remove the screw (silver-colored M4)
to remove the cord-FG
.
(9) Remove three screws (black-colored, L=8mm)
to remove the Plate-Board (SU) .
(10) Remove two screws (black-colored, L=10mm) to remove the Cover-Assy-LF .
(11) Remove four screws (black-colored, L=10mm) to remove the Cover-Hinge-L
and the Plate-Hinge-L (Caulking) .
(12) Remove seven screws (black-colored, L=10mm M4 )
to remove the Cam-hinge .
Note! (to assemble)
1. Since a cable will be pushed by Plate-Shield (SU), please place downward.
(2)
Remove four screws (black-colored, L=10mm) to remove the Cover Bottom .
(3) Remove Plate-FG (FAX) from Cover Bottom
.
(4) Remove five screws (silver-colored) and five screws (black-colored, L=8mm)
to remove the Plate-Shield (SU) .
(5) Remove the screw (silver-colored)
to remove the Clamp . And remove all SU-
Board cables.
4.2.7.15 Frame-assy-FB
Note! •ItexchangesitdetachingthescannerunitfromtheMFPwhentheSU-board
is exchanged.
• If replaced new board, update Firmware according to Chapter 9.3.
It is necessary to take the synchronization of the rmware version of SU
board and CU board.
(1) Remove the screw (silver-colored M4)
. (Only MC562)
⑧
⑨
NG(The cable upward)
OK
The cable with the shield should be
in the highest position.
(6) Remove the screw (silver-colored M4) to remove the Plate-FG . (Only MC562)
Remove four screws (silver-colored)
to remove the SU-Board .
To Next Page
Loading...
Need help?
General
