4 Handling and Installation Environment
4 - 2
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
4-1 All Series
Precautions for Safe Use
Installation Environment
• Do not use the product in areas where flammable or explosive gases are present.
• Install the product so that air can flow freely through its cooling vents.
• Clean the ventilation holes and fan outlet regularly to prevent dust and particles from clog-
ging them. If they are blocked, heat is trapped inside, causing a malfunction.
• Do not install the product close to high-voltage devices and power devices in order to secure
the safety of operation and maintenance.
• Make sure to tighten all installation screws securely.
Handling of Sensor Controller
• Do not attempt to dismantle, repair, or modify the product.
• Do not drop the product nor apply excessive vibration or shock to the product.
Doing so may cause malfunction or burning.
• This product is heavy. Be careful not to drop it while handling.
• When disposing of the product, treat it as an industrial waste.
• A lithium battery is incorporated, so a severe injury may rarely occur due to ignition or explo-
sion.
This product must be used according to this manual or Instruction Sheet. Failure to observe
this may result in impairment of functions and performance of the product.
This product is not designed or rated for ensuring safety of persons.
Do not use it for such purposes.
A lithium battery is built into the Sensor Controller and may occasionally combust, explode, or
burn if not treated properly. Dispose of the Sensor Controller as industrial waste, and never
disassemble, apply pressure that would deform, heat to 100°C or higher, or incinerate the
Sensor Controller.
To Next Page
Loading...
Need help?
General
