4 Handling and Installation Environment
4 - 4
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
4-2 FH-1000/FH-3000 Series
Precautions for Correct Use
Ambient Temperature
• Install and store the product in a location that meets the following conditions:
• Surrounding temperature of 0 to 50°C (-20 to +65°C in storage)
• Relative humidity of between 35 to 85%RH
• Do not let the ambient temperature exceed 50°C (122°F).
• Provide a forced-air fan cooling or air conditioning if the ambient temperature is near 50°C
(122°F) so that the ambient temperature never exceeds 50°C (122°F).
Orientation of Product
• For good heat dissipation, install the product only in the position shown below so as not to
block the ventilation holes.
• Do not install the product in the following positions.
• For good ventilation, provide a clearance of 50 mm or more above the sensor controller away
from other devices in the normal floor mounting. For the right and left sides, provide a clear-
ance of 30 mm or more, and for the back side, 15 mm or more. These clearances are also
required when mounting multiple sensor controllers side by side. For the back mounting, the
back-side clearance of 15 mm is nor required.
Handling a SD memory card
• Before removing SD memory card, make sure that data is not being read or written to it.
• Do not insert an SD memory card in the reverse orientation, at an angle, or in a twisting man-
ner.
• For an SD memory card, the SD BUSY LED of Sensor Controller flashes while data is being
read or written.
Make sure that the LED stops flashing before removing the card.
To Next Page
Loading...
Need help?
General
