5 Setup and Wiring
5 - 26
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
5-4 Setup Touch Panel Monitor or Moni-
tor
Describes the notifications of Sensor Controller when you setup Touch Panel Monitor or Monitor.
For handling or functions of monitor, refer to each of instruction sheet.
Precautions for Safe Use
• Use only the cables designed specifically for the product. Use of other products may result in
malfunction or damage of the product.
• Always turn OFF the power of the Sensor Controller and peripheral devices before connect-
ing or disconnecting a camera or cable. Connecting the cable with power supplied may result
in damage of the camera or peripheral devices.
• Do not apply torsion stress to the cable. It may damage the cable.
• Secure the minimum bending radius of the cable. Otherwise the cable may be damaged.
Precautions for Safe Use
• Please insert DVI-I connector perpendicularly so that the connector resin part and pin are not
rubbing against each other. Damaged pin may cause contact failure due to generation and
invasion of resin powder.
• When you connect FH-1000 series or FH-3000 series to the FH-MT12 via USB cable:
Do not ground the positive terminal of DC24V power source. The internal circuit is possible to
be given damage, it can be cause the failure.
Precautions for Correct Use
When connect the Sensor Controller and monitor with a switcher and splitter
Do not use devices that make the Sensor Controller recognize the monitor again when switch-
ing operation is performed. Re-recognition process in switching operation has an effect such as
a delay in measurement time.
When fix the DVI connector
If difficult to fix the bilateral screws of DVI connector, once loosen these. Then retry to fix, again.
5-4-1 All Series
5-4-2 FH-1000/FH-3000 Series
To Next Page
Loading...
Need help?
General
