5 Setup and Wiring
5 - 34
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
5-7 Use by Connecting Software
Sysmac Studio FH tool, FZ_FH Remote Operation tool, and Simulation Software are dedicated soft-
ware.
Sysmac Studio FH tool is supported only FH-1000 and FH-3000 series.
When you purchase these series newly, both software DVD and icons are required.
Additional Information
For Sysmac Studio FH tool, refer to the Vision System FH Series Operation Manual for Sysmac
Studio (Cat. No. Z343).
FZ_FH Remote Operation tool is supported all of the series; FH-1000, FH-3000, FH-L, FZ5, and FZ5-L
series.
When you purchase these series newly, both software DVD and license are required.
Additional Information
For details of FZ_FH Remote Operation tool, refer to Remotely Operating the Controller
(Remote Operation) section in the Vision System FH/FZ5 series User’s Manual (Cat. No.
Z365).
Using the Simulation Software, you can check the operation or functions of Vision System FH/FZ5
series on a PC.
Additional Information
For using the Simulation Software, refer to the description of How To Use Simulation Software.
5-7-1 Sysmac Studio FH Tool
5-7-2 FZ_FH Remote Operation Tool
5-7-3 Simulation Software
To Next Page
Loading...
Need help?
General
