Omron OMNUC R88D-WT15HF User Manual

4-152
4-11-10 Checking the Version
H Version Check (Fn012)
• You can use this function to check the Servo Driver and encoder software versions.
System Check Mode
Version check
Servo Driver software ver-
sion displayed.
Encoder software ver-
sion displayed.
1 s min.
1 s min.
Operation Procedure
PR02W
operation
Front panel
key operation
Display Explanation
Press the MODE/SET Key to change to System Check
Mode.
Press the Up or Down Key to set function code Fn012.
(See note.)
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s
min.). Driver software version is displayed as
“r.jjjj.”
Press the MODE/SET Key. Encoder software version is
displayed as “E.jjjj.”
(1 s min.)
Press the DATA Key (front panel: DATA Key for 1 s min.)
to return to the System Check Mode function code
display.
Note The digits you can manipulate will flash.
Operation Chapter 4

Omron OMNUC R88D-WT15HF Specifications

General

Brand	Omron
Model	OMNUC R88D-WT15HF
Category	Servo Drives
Language	English