Polaris 2012 RANGER RZR 570 INTL User Manual

3.72
ENGINE / COOLING SYSTEM
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
10. Torque new flywheel nut (B) to specification.
11. Install starter idler gear and shaft (C).
Stator Removal
NOTE: Test stator wire continuity before removing it
from the housing.
1. R
emove the stator cover as o utlined in the ”Water
Pump Me chanical Seal / Oil Se al Re placement”
procedure” in this chapter.
2. Remove and discard the st
ator cover gasket.
3. Remove the 3 bolts (C) that secure the stator to the
st
ator cover.
4. Remove the 2 bolts that secure
the stator wire routing
bracket (D) to the stator cover.
5. Remove the stator (E) from the stator cover.
= T
Flywheel Retaining Nut:
133 ft. lbs. (180 Nm)
C
B
CAUTION
The flywheel contains powerful magnets.
Use caution when removing the stator cover.
DO NOT place fingers between cover and
crankcase at any time during the removal
process or injury could result.
CAUTION
Be sure engine coolant does not contaminate
the engine oil during stator cover service.
C
D
E
6 ft. lbs.
(8 Nm)
9 ft. lbs.
(12 Nm)
Apply Loctite
Apply Loctite
Apply Crankcase
Sealant

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English