Polaris 2012 RANGER RZR 570 INTL User Manual

7.10
FINAL DRIVE
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
20. Pull ou t on the drive sha ft to cen ter the jo int in the
housing. Slide a straight O-ring pick or a small slotted
screw driver between the large end of the boot and the
joint housing and lift up to equalize the air pressure in
the boot.
21. Position the boot lip in its groove. Install
and secure
the boot with the lar ge cla mp using th e “earless”
clamp pliers.
Drive Shaft Installation
1. Install new spring ring on drive shaft. Apply an anti-
seize compound to splines.
2. Align splin es of d rive sha ft with fro nt gearcase an d
reinstall the drive
shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary
3. Install drive shaft into the front bearing carrier.
4. Install the upp er ball joint end into th e front bearing
ca
rrier.
CV Boot Clamp Pliers
Earless Type: 8700226
FRONT DRIVE SHAFT
Grease Capacity
80 Grams
Grease Capacity
80 Grams
Plunging
Joint
CV Joint
Apply
Anti-Seize
NEW
Spring Ring

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English