2.33
MAINTENANCE
2
9923523 - RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
Engine To Frame Ground
Inspect ground cable connections. Be sure they are clean
and tight.
The engine ground cable runs from the upper starter motor
mo
unting bolt to the chassis ground terminal.
The Chassis ground is located under the drivers seat, near
the
starter solenoid.
STEERING
Steering Inspection
The steering components should be checked periodically
for lo ose fa steners, wor n tie ro d e nds, b all jo ints, and
damage. Also ch eck to make sure all cotter pin s are in
place. If cotte r pins are removed, they mu st not be re–
used. Always use new cotter pins.
Replace any wor n or da maged steer ing com ponents.
S
teering should move freely through the entire range of
travel without binding. Check routing of all cables, hoses,
and wirin g to b e sur e the steer ing mech anism i s n ot
restricted or limited.
NOTE: Whenever s teering c omponents are
replac
ed, check front end alignment.
Due to the critical nature of the procedures
outlined in this chapter, Polaris recommends
steering component repair and adjustment be
performed by an authorized Polaris
MSD certified technician.
Use only genuine Polaris replacement parts.
To Next Page
Loading...
Need help?
General
