To Next Page

To Previous Page

7.4

FINAL DRIVE

9923523 - 2012 RANGER RZR 570 Service Manual

Bearing Installation

5. Thoroughly clean th e fro nt bea ring car rier ho using

nd the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

6. Support the bottom of the bearing carrier housing.

7. Apply Loct

ite® 60 3™

retaining comp ound to the

outer circumference of th e ne w bearing r ace and

carefully pr ess the ne w b earing into the b earing

carrier housing.

NOTE: Use ca re to not allow any of t he L octite®

compound to get in the bearing.

8. Wipe the housing clean of any excess compound and

ins

tall the snap ring.

Bearing Carrier Installation

1. Install drive shaft axle through th e b ackside o f the

bearing carrier.

2. Install the upper and lower ball joint ends into the front

bea

ring carrier.

3. Install pinch bolts and torque to specification.

4. Apply grease to drive shaft axle splines.

CAUTION

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

Apply

Loctite® 603™

Bearing

Snap Ring

= T

Ball Joint Pinch Bolts:

23 ft. lbs. (31 Nm)

23 ft. lbs.

(31 Nm)

Polaris 2012 RANGER RZR 570 INTL User Manual

Questions and Answers: