Polaris 2012 RANGER RZR 570 INTL User Manual

2.38
MAINTENANCE
9923523 - RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
Parking Brake Cable Adjustment (INTL)
When the parking brake is fully engaged and “BRAKE” is
displayed on the instrument clu ster, en gine spe ed is
limited to 1500 RPM while in gear. If throttle is applied, this
limiting fea ture pr events op eration, wh ich pr otects the
parking brake pads from excessive wear.
NOTE: Inspect the parking brake cable tension after
t
he first 25 hours of operation and every 100 hours
of operation af terwards to ens ure prop er cab le
tension.
Loss of tension in the p arking brake cable will caus
e
illumination of the parking brake indicator and activation of
the limiting feature. If this occurs, inspect an d a djust
parking brake cable tension. If performing this service is
difficult due to conditions o r location , temporarily
disconnect the parking brake switch electrical connector.
Reconnect th e co nnector as so on as practicable an d
adjust the parking brake cable to proper tension.
1. Pull back on the parking brake lever (located in dash).
2. After 3 t o 4 clic ks “BRAKE ” should display on the
i
nstrument cl uster a nd th e whe els of the vehicle
should not rotate when turning by hand. After 8 fu ll
clicks of lever travel, the vehicle should not roll while
parked.
3. If the vehicle moves, adjustment is necessary.
4. Adjust the pa rking brake cable wh ere th e ca ble
a
ttaches to the caliper mount / shift cable bracket. The
mount bracket is located on the right-hand side of the
transmission.
Adjustment Procedure: Refer to Chapter 9 “Brakes”
f
or complete adjustment procedure.
Parking Brake Pad Inspection (INTL)
Inspect t he p arking br ake ca liper br ake p ad thickness.
Replace brake pads if damaged or worn beyond service
limit. Replac e caliper ass embly if damage or excessive
wear is found. Refer to the following image for brake pad
specifications.
Inboard
Pad
Outboard
Pad
Outboard Pad Thickness
New 0.250” (6.35 mm)
Limit: 0.190” (4.83 mm)
Inboard Pad Thickness
New 0.300” (7.62 mm)
Limit: 0.240” (6.10 mm)

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English