Polaris 2012 RANGER RZR 570 INTL User Manual

7.24
FINAL DRIVE
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
8. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
9. Be sure the armature plate tabs are fully engaged into
the
ro ll ca ge asse mbly a nd a re re sting on th e cut-
grooves of the ring gear.
NOTE: Verify armature plate tabs are in the slots on
t
he roll cage and are resting in the ring gear grooves.
10. Carefully install the ring gear and roll cage assembly
in
to the gearcase housing.
11. Install a new O-ring on the cover plate assembly.
NOTE: Be su re the sq uare O-ring is p laced f lat on
t
he c over s urface. If th e O- ring i s t wisted f luid
leakage may occur.
12. Carefully install the LH outpu
t hub assembly into the
cover plate. Take care not to damage the new cover
plate seal while installing the output hub.
13. Install the output cover assembly onto the gearcase
hou
sing. Install the (7) cover plate screws and torque
to specification.
Engage
Tabs
= T
Cover Plate Screws:
7-11 ft. lbs. (10-15 Nm)
LH Hub
Torque Screws

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English