2.17
MAINTENANCE
2
9923523 - RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
3. If needed, start the engine and allow it to idle for three
minutes until warm. Stop the engine.
4. Place a d rain pa n b eneath e ngine cr ankcase a nd
r
emove the drain plug.
5. Allow oil to drain completely.
6. Replace sealing washer on drain plug.
NOTE: The sealing surface on the drain plug should
be
clean and free of burrs, nicks or scratches.
7. Reinstall drain plug and torque to 1
2 ft. lbs. (16 Nm).
8. Place a drain pan under vehicle below the oil filter.
9. Place shop towels beneath oil filter. U
sing Oil Filter
Wrench (PU-50105) and a 3/8” extension, turn the oil
filter counter-clockwise to remove it.
10. Using a clean dry cloth, clean filter sealing surface on
the crankcase.
11. Lubricate O-ring on n ew filter with a film o f fre sh
en
gine oil. Check to make sure the O-ring is in good
condition.
12. Install new filter an d turn by hand until filter gasket
co
ntacts the sealing surface, then turn an additional
1/2 turn.
13. Remove the engine o il dipstick (see “Eng ine Oil
Le
vel”).
14. Using a long funnel, fill the sump with 2 qts. (1.9 l) of
PS-
4 Plus Synthetic Engine Oil (2876244).
15. Verify the transmission is still
positioned in PARK (P).
16. Start the engine and let it idle for two minutes.
17. Stop the engine and inspect for leaks.
18. Re-check the oil level on the dipstick and add oil as
n
ecessary to bring the level to the upper mark on the
dipstick.
19. Dispose of used oil and oil filter properly.
Oil may be hot. Do not allow hot oil to come into
contact with skin, as serious burns may result.
Drain Plug
NOTE: Drain plug is accessed
through the skid plate.
Crankcase Drain Plug Torque:
12 ft. lbs. (16 Nm)
Oil Filter Torque:
Turn by hand until filter gasket contacts sealing
surface, then turn an additional 1/2 turn
Oil Filter Wrench:
PU-50105: 2.5” (64 mm)
To Next Page
Loading...
Need help?
General
