3.28
ENGINE / COOLING SYSTEM
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
9. Remove the outer clutch cover, drive belt, drive clutch,
driven clutch and inner clutch cover (see Chapter 6).
Make note of hose and wire routings for reassembly.
IMPORTANT: Be sure to use the correct Drive Clutch
Puller
(PA-48595) to prevent damage to crankshaft.
10. Disconnect the stator wire connector and cut the tie
stra
p secur ing the wir ing to th e fro nt engine mount
bracket. Replace tie strap for engine installation.
11. Remove the CPS sensor from the stator cover on the
r
ight-hand side of the en gine. Plug CPS h ole with
clean shop towel. Inspect CPS O-ring and replace if
needed.
12. Disconnect the IAC valve (A), TPS (B), T-MAP sensor
(C), har
ness leads from the throttle body.
13. Disconnect the fuel injector harness lead (D) from the
fuel injec
tor.
14. Properly relieve fuel pressure from the fuel rail.
15. Place a shop to beneath the fuel line quick connector
to
catch any excess fuel. Disconnect the fuel line (E)
from the fuel rail by pressing in on the quick connector
tabs.
16. Move fue l line to th e left-h and sid e of th e en gine
co
mpartment. Make note of line routing for
installation.
17. Disconnect the ignition coil har ness co nnector an d
rem
ove the spark plug wire from the engine.
To Next Page
Loading...
Need help?
General
