Wiper Process
If you want to check the wiper process, follow the procedure below.
How to Process the Wiper
1. As supervisor (see How to Log in as Supervisor on page 144):
Press and select the path: Maintenance Cartridge Wiper Process
2. Open the cover and remove the headset.
3. Press [OK] twice to start the carriage motor.
4. Check wiper and clean if neccesary, then press [OK].
5. Check headset is back in replacement position and press [OK] to end test.
Manual Cleaning
If automatic cleaning is not sufficient, you can clean the printing heads manually.
198
| Page 198 | Jul-31-2018 12:32 |
10
Maintaining your Mailing System
To Next Page
Loading...
Need help?
General
