Raisecom Technology Co., Ltd
55
10.4.2. Line-Board information (RAM):
In device set query menu press number key 2, and then there will be device Line-Board
information:
Real information:
Line-Board Type:2E1 Board (Line-Board card name)
Device Query Command:1-8, Menu Display:M, Return:Q Command:
There will be Line-Board name for each Line-Board card. If a Line-Board card cannot be
configured there will not be configuration information and status information. At present
only optical Line-Board card has configuration information as follows:
Real information:
Line-Board Type:Optical Board
Software Version:REV A.0 Hardware Version:REV A.0
Optical Modul Type:S1
Alarm Mask: 1=Mask Optical LOS| Frame LOF | E-3 ERROR | E-6 ERROR
Local: 0 0 0 0
Remote: 0 0 0 0
Loopback State:No Loopback
Ether Net Set:
Ether Net E-Port:Open Link State:Link Down
Ether Net State:Auto Adapt 10M Half Duplex Enable AUTO_MDI/MDIX
Send Limited Bandwidth:4095 x 32Kbps
Receive Limited Bandwidth:4095 x 32Kbps
Device Query Command:1-8, Menu Display:M, Return:Q Command:
2E1 Line-Board:
Line-Board Type:2E1 Board
4E1 Line-Board:
Line-Board Type:4E1 Board
10.4.3. Line-Board information (EEPROM):
In device set query menu press number key 3, and then there will be device Line-Board
information:
EEPROM Set:
Line-Board Type:2E1 Board
Device Query Command:1-8, Menu Display:M, Return:Q Command:
Please refer to Line-Board information (RAM) for Line-Board information explanation:
To Next Page
Loading...