Raisecom Technology Co., Ltd
70
10.10.1. Alarm Mask Set
In optical line-board set menu press number key 1 to configure optical alarm mask:
Optical Alarm Mask Set:
Local Optical Loss:(Enable)
In this statu use → key to disable or enable alarm mask; use ↓↑to change items (alarms);
Press ENTER to confirm configuration, press E key to finish configuration, and ESC to
cancel configuration.
The alarms are:
Local Optical Loss;Local LOF; Local E-3 ERR; Local E-6 ERR;
Remote Optical Loss; Remote LOF; Remote E-3 ERR; Remote E-6 ERR
10.10.2. Loopback Set
In optical line-board set menu press number key 2 to configure loopback of optical line:
Optical Loopback Set:
Loopback Direction:Remote
In this statu use → key to change configured value; use ↓↑to change configuration items;
Press ENTER to confirm configuration, press E key to finish configuration, and ESC to
cancel configuration.
The configuration items are:
Loopback Direction; 1E1 Loopback; 2E1 Loopback; 3E1 Loopback; 4E1 Loopback
10.10.3. ALS Set
In optical line-board set menu press number key 3 to configure ALS function (the
precondition is optical module has this function):
ALS function: Enable
In this statu use → key to change configured value (enable or disable); Press ENTER to
confirm configuration, press E key to finish configuration, and ESC to cancel
configuration.
If the optical module does not have this function there will be prompt:
Optical Model hasn't ALS function, Can't be set.
Optical Board
Set Command:1-8, Menu Display:M, Return:Q Command:
10.10.4. Ether Net Port Set
In optical line-board set menu press number key 4 to configure Ethernet interface:
Ether Net Port:Open
In this statu use → key to change configured value (open or close); Press ENTER to
confirm configuration, press E key to finish configuration, and ESC to cancel
configuration.
To Next Page
Loading...
Need help?
General
