Raisecom Technology Co., Ltd
7
2. Overview
2.1. Introduction
RC3000 is a PCM multi-service multiplexer that uses both traditional and modern
technologies, and can provide a high reliable access at a low cost along with multi
functions, easy application and maintenance.
2.2. Main features:
z Multiple up-link access methods（single E1, multi E1, optical interface and etc）.
z Available to various user-boards, and supports many kinds of voice and data access,
including: Ethernet data, V35 data, V24 data and series data.
z E1 interface supports both G703 and G704 standards, and is available for PCM30
or PCM31 frame format.
z Supports multi E1 interfaces and non-blocking timeslots cross-connect of 4 E1
based on 64K, it is very convenience for point-to-multipoint access application and
can save both devices and money for our costumers.
z Use large integrated circuit module and programmable logic circuit, and there are
multi kinds of check methods in control program to make sure of stable work.
z Supports hot swap, the user configuration will not be changed and is easy to
maintain.
z Auto recognization and configuration of user-board, for simple application the device
can start to work without any configuration.
z Master/slave clock mode supports clock holding, locking and free running to easy
your work and reduce wrong operations.
z Easy configuration of E1 mode and line signal enables flexible access with other E1
interfaces of different factories.
z Supports hyper terminal configuration, and is very convenience for maintenance
and fault detection.
z Supports field upgrade in local and remote network management upgrade
z Save data in EEPROM and check the data by many methods to avoid data loss or
destroyment.
To Next Page
Loading...
Need help?
General
