Raisecom Technology Co., Ltd
71
10.10.5. Ether Net Port Work Set
In optical line-board set menu press number key 5 to configure Ethernet interface work
status:
Ether Net Work State Set:
Auto Mode:Enable
In this statu use → key to change configured value (enable or disable); use ↓↑to change
configuration items; Press ENTER to confirm configuration, press E key to finish
configuration, and ESC to cancel configuration.
The configuration items are: Auto Mode: Enable/Disable
Port Mode: Full Duplex/Half Duplex
Port Speed: 100M/10M
AUTO_MDI/MDIX: Enable/Disable
10.10.6. Transmit Band Width Set
In optical line-board set menu press number key 6 to configure Ethernet interface Tx
Band Width:
Transmit Band Width: 4095 x 32Kbps
Set (0-4095):
The first row is present configuration value and the second row is for your configuration.
If you do not set bandwidth value in the second row and just press ENTER, the old
configuration will be reserved. If you set the bandwidth value (the entering can only be
number and within the range of 0-4095) and press ENTER, the new configuration will be
effective. BackSpace key is available to modify the input value.
10.10.7. Receive Band Width Set
In optical line-board set menu press number key 7 configure Ethernet interface Rx
Bandwidth:
Receive Band Width:4095 x 32Kbps
Set(0-4095):
The first row is present configuration value and the second row is for your configuration.
If you do not set bandwidth value in the second row and just press ENTER, the old
configuration will be reserved. If you set the bandwidth value (the entering can only be
number and within the range of 0-4095) and press ENTER, the new configuration will be
effective. BackSpace key is available to modify the input value.
10.10.8. Reset Ether Net
In optical line-board set menu press number key 8 to reset the Ethernet interface:
To run this command will reset ether net port.
To Next Page
Loading...
Need help?
General
