Raisecom Technology Co., Ltd
80
In this statu use → to change the configured value: Retain & Clear, press ENTER to
confirm.
In the configuration process press ESC to exist and the above configurations will be
invalid.
(There are seven steps of this configurarion: Group No. for Time Slot Out, Time Slot Start
No. for Time Slot Out, Group No. for Time Slot In, Time Slot Start No. for Time Slot In,
Time Slot Number for Create Cross, Create Mode:Bi-direction, Deal Mode for Old
Relation Data)
Users can use these commands when set a continuous cross connect, for example the
next cross connect is required:
Bi-direction cross connect the 1-5 channel of cross group 1 with 9-13 channels of cross
group 5 (first user E1) and clear the old configurations, you can use these commands as:
Group No. for Time Slot Out:1
Time Slot Start No. for Time Slot Out:1
Group No. for Time Slot In:5
Time Slot Start No. for Time Slot In:9
Time Slot Number for Create Cross:5
Create Mode:Bi-direction
Deal Mode for Old Relation Data:Clear
Then the required cross connect will be set.
10.16.3. Delete Group Cross
In cross set menu press number key 3 to delete group cross:
Group No. for Delete Cross:
The entering must be a number from 1 to 8, press ENTER to confirm and start the
configuration of next item. The system will check the entered number, if invalid it will be
discard; if valid there will be next item configuration.
Time Slot Start No. for Delete Cross:
The entering must be a number from 1 to 31, press ENTER to confirm and start the
configuration of next item. The system will check the entered number; if invalid it will be
discard; if valid there will be next item configuration.
Time Slot Number for Delete Cross:
The entering must be a number from 1 to 31, press ENTER to confirm and start the
configuration of next item. The system will check the entered number; if invalid it will be
discard; if valid there will be next item configuration.
Delete Relation:Retain
In this statu use → to change the configured value: Retain & Clear, press ENTER to
confirm, and the relative cross connect will be deleted.
(There are four steps of this configurarion:, Group No. for Delete Cross, Time Slot Start
No. for Delete Cross, Time Slot Number for Delete Cross, and Delete Releation: delete
this group or delete both this group and the retain group.)
Users can use these commands when delete a continuous cross connect, for example
the next cross connect is required:
To Next Page
Loading...
Need help?
General
