Raisecom Technology Co., Ltd
78
10.14.4. Default Port Mode
In Ethernet user board set menu press number key 4 to set the default port mode:
Default Port Model:Half Duplex
In this status use → key to change the configured value: Full duplex of Half duplex;
Press ENTER to confirm configuration, press E key to finish configuration, and ESC to
cancel configuration.
Note: default port mode refers to the mode when Ethernet electric interface is LINK
DOWN, and when Ethernet electric interface is LINK UP it is in auto negotiation mode.
10.14.5. Reset Ether Net Port
In Ethernet user board set menu press number key 5 to reset the Ethernet electric
interface and there will be the confirm prompt:
To run this command will reset ether net port.
Run this command (Y/N):
In this status press Y to reset the board and press N to cancel the operation. Other
enterings are invalid.
10.15. RS232 and RS422 user-board set menu
This section will explain the commands of RS232 & RS422 user-board menu:
10.15.1. Channel Band Width Set
In user board set menu press number key 1to configure channel band width::
Channel Band Width:64Kbps
In this status use → key to change the configured value: 64Kbps, 128Kbps, 256Kbps
and 512Kbps; Press ENTER to confirm configuration, press E key to finish configuration,
and ESC to cancel configuration.
Note: bandwidth set of RS232 & RS422 has not been fully realized now, and this function
is reserved.
10.16. Cross Set menu
In set menu press number key 2 there will be Cross Set menu:
1.Cross Set
2.Create Group Cross
3.Delete Group Cross
Cross Set Command:1-3, Menu Display:M, Return:Q Command:
To Next Page
Loading...
Need help?
General
