2
Basic
Operation
Loading Media
39
Loading the Sheet Media
Procedure
Move the media holders to the left and right.
Move them to a location where they don’t disturb the media when the media is hung down from the
rear of the machine. If they disturb the media, remove them with the shaft. For information on how to
remove, refer to “Setup Guide.”
Pass the media through the printer and secure the media holders.
Procedure
2.
to
of [Loading Roll Media]
Align the front edge of the media with the location shown in the gure.
Loosen.
Align here.
Loosen.
To Next Page
Loading...
Need help?
General