2
Basic
Operation
49
Outputting
Setting the Output-start Location
When p. 43, "Setup of Media" are completed, you can set the output-start location at any location you prefer.
(You can output even if you do not set this.) Move the media and the print head to set the output-start location.
Note, however, that this setting must be made for each individual page.
Procedure
Open the front cover.
Use to move the media and the heads.
If you press a cursor key, preparation operation to move the media or the print head starts.
After the operation nishes, move the media and the print head to the location where you start the output.
When the location is set, press .
When the left gure is displayed, press to enable the
setting.
remains steadily lighted and when the screen displays the output-
possible width at the location, setting is completed.
FUNCTION
BASE POINT
Ｗ１２００ｍｍ
Base point
mark
Scan-direction start location
Cutter groove
Feed-direction start location
Scan (horizontal) di-
rection start location
Output-start
location
Feed (vertical) direction
start location
Scan (horizontal) direction
start location
The settings of feed-direction and scan-direction locations
determine the output-start location.
Printing area
Move the media to adjust the feed
direction.
The base point mark on the right side of the print
head indicates scan-direction start location.
Feed (vertical)
direction start
location
To Next Page
Loading...
Need help?
General