Fully Utilize the Media Heating System
4
Part of
Practice
90
Press several times to display the left gure.
Press
twice.
Press to select “ENABLE.”
Press
to enable the setting.
Press to go back to the original screen.
Description
"ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
The margin between the print-end position and the next print-start position is set to a value of 100 mil-
limeters. When a margin setting of less than 100 millimeters has been made on the RIP software computer,
that setting is ignored, but when a margin setting of greater than 100 millimeters has been made on the
computer, the computer's setting is used for the margin value..
"DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Setting the Drying Time after Printing
Procedure
Press .
Press several times to display the left gure.
Press
, and then .
Press .
Press to select the interval.
Press
to enable the setting.
Press to go back to the original screen.
Description
Set the interval after the 1st page is printed. The next operation is not started until the set time passes.
is lighting during the interval. When pressing while is lighting, the interval is nished and
the next operation is started. When holding on
while is lighting, output is canceled.
Default Setting
[DRYING TIME]: 0 min
FEED FOR DRY
DISABLE
ENABLE
W1200mm
SETUP SHEET
W1200mm
SETUP SHEET
To Next Page
Loading...
Need help?
General