Applied national standards and technical specifications:
• IACS UR M10: Rev.4 2013
• IACS UR M67: Rev.2 2015
• IEC 60079-0 (2019) and IEC 60079-28 (2016-04)
1.9 Liability for defects
The terms in the order confirmation from Schaller Automation Industrielle
Automationstechnik GmbH & Co. KG or the terms agreed in the contract apply.
Claims for personal injury and damage are excluded if they are due to one or more of
the following causes:
• use not as intended
Section 4.5 Foreseeable misuse
• foreseeable misuse
Section 4.5 Foreseeable misuse
• technical data
Section 3.4 Technical data
• technical description
Section 4.3 Technical description and technical data
1.10 Terms of warranty
The terms of warranty are part of the “General Terms and Conditions” or the purchase
contract.
The warranty provided by Schaller Automation Industrielle Automationstechnik GmbH &
Co. KG does not apply in the following cases:
• Incorrect installation, maintenance and servicing of the device, by insufficiently
qualified personnel.
• Operating the device with safety devices that are not properly attached or are
not functioning.
• Failure to observe the instructions, commands and prohibitions in the operating
manual.
• Unauthorised structural changes to the device.
• Inadequate monitoring of wear parts.
• Maintenance work not carried out correctly or not carried out on time.
• Unauthorised modifications to the device may invalidate the warranty.
• Retrofitting and modifications to the device or installation kit are only allowed
after consulting Schaller Automation Industrielle Automationstechnik GmbH &
Co. KG;
• Transport damage as a result of incorrect handling.
The following also applies in addition:
Statutory regulations must be observed.
Do not make any unauthorised changes or manipulate the device.
Only use correct and approved materials.
Only use approved and suitable spare parts. Section 13.1 Spare parts list
Normal wear and tear is not a “malfunction” for the purposes of the terms of
warranty.
To Next Page
Loading...
Need help?
General
