Operating manual VISATRON® Oil Mist Detector VN2020 / VN2020 EX
Part number 183001 Version 3.0
ASSEMBLY AND INSTALLATION
If the oil mist detector is operated in explosion-proof areas, the relevant safety
instructions must be observed.
Section 2.4.1 Safety instructions for potentially explosive
atmospheres
6.3 Assembling the system components
Safe and correct assembly of the device
For assembly, read the operating manual and other documents accompanying
the product with care and keep them in a suitable place for future reference.
Personal protective equipment
Operating the device or working on the device without protective equipment may result
in serious injury. For the workplace PPE, the following protective equipment must be
used:
DIN EN 388:2016 Protective gloves against mechanical risks, 2341X,
and DIN EN 407:2004 Protective gloves against thermal risks, X1XXXX
Safety glasses in accordance with DIN EN 166 or DIN EN 170
Safety helmet in accordance with DIN EN 397 and DIN EN 50365
Hazards during assembly
There is a risk of serious injury, including death, from explosion in the crankcase as a
result of incorrect assembly or installation.
You may only assemble the oil mist detector when the engine is switched off
and the system has been disconnected from the power supply first! The
compressed air supply to the oil mist detector must also be switched off first.
Before assembly, the housing of the VISATRON
®
VN2020 / VN2020 EX oil
mist detector must be earthed.
Failure to comply with the safety instructions may result in major damage to property
or the environment and in serious injury or death.
Familiarise yourself with the basic safety instructions before starting assembly.
Section 2.4 Basic safety instructions
To Next Page
Loading...
Need help?
General
