Siemens simovert masterdrives Compendium

05.2003 Function Blocks and Parameters
Siemens AG 6SE7087-6QX70 (Version AD)
SIMOVERT MASTERDRIVES Compendium Motion Control 4-1
4 Function Blocks and Parameters
A large number of open-loop and closed-loop control functions,
communication functions, as well as diagnostics and operator control
functions are implemented in the software of the converters and
inverters by means of function blocks. These function blocks can be
parameterized and freely interconnected.
The interconnection method can be compared with electrical circuit
engineering where various function units, e.g. integrated circuits or
other components are interconnected by cables.
The difference is, however, that function blocks are interconnected not
by cables, but via software.
4.1 Function blocks
Functions are implemented in function blocks. The function scope of
the individual function blocks depends on its special task.
The function blocks are provided with inputs, outputs and parameters
and are processed in time slots.
K0153
M(set)
Gain Time
n-Reg. gain
0.0 ... 200.0
P235.F (1.0)
M(set)
n-Reg. time
0 ... 1000 ms
P240.F (100)
P228.B
KK0152
Deviation
n-Reg.release
of sequence control
[460.8]
r238
B0310
Binector
Connector
parameter
Function
parameter
Visualization
parameter
Connector
Function block
U953.14 = 2
Parameter for time slot
table
Fixed
connection
Function block number
Time slot
Cross-reference to other function diagram [page.column]
Fig. 4-1 A function block
Control functions

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English