Function diagram
87654321
fp_mc_850_e.vsd
Technology option
MASTERDRIVES MC
02.02.04
Enabling with PIN number
-850 -
It is necessary that the F01 technology option has been enabled:
The F01 technology option can only be used with MASTERDRIVES MC units which have been delivered ex-works with the enabled F01 option or for which this option has been enabled
retrospectively by means of a PIN number. The display parameter n978.1 = 1 can be used to check if the F01 is present:
n978.1 = 2 ==> Technology option F01 is enabled for 500 h
n978.1 = 1 ==> F01 technology option has been permanently enabled
n978.1 = 0 ==> F01 technology option has been disabled
The technology function remains enabled even after a software update and does not have to be entered again after new software has been loaded into the flash E PROM.
Enabling of the "F01 technology option" (positioning and synchronization)
Temporary enabling of the F01 technology option (free of charge):
For all units and electronics boards, the F01 technology option can be enabled free of charge with a special PIN No.. This can be done once for a
trial period of 500 hours. This time can be used for testing purposes or for using substitute units which have been ordered without the F01 option as
long as the PIN number has not yet been received. The operating-hours counter (r825) determines when this time has expired. Only that time is
counted during which the drive is on. After the 500 hours have expired and the voltage supply has been turned off, the F01 option is disabled again
unless the 'normal' PIN has been entered in the meantime. The 500 hours can no longer be interrupted (e.g. by changing the PIN entries).
Input of the special PIN number can only be done via the PMU. The special PIN is the same for all units and is as follows
U977.1= 0727, U977.2 = 0101
Retrospective enabling of the F01 technology function (involves extra costs):
Proceed as follows if you want to permanently enable the F01 technology option retrospectively
1) Determine the factory serial number of the MASTERDRIVES unit electronics. There are two ways of doing this:
a) From parameters U976.01 and U976.02, you can read out the last 8 figures of the factory serial number which are necessary for determining
the PIN number.
(Example: U976.01 = 3032
, U976.02 = 4198 ==> Factory serial number = ... 30324198)
b) The serial number can also, if necessary, be obtained from a MASTERDRIVES unit without connecting it to the supply.
- In the case of Compact PLUS units, it is on the sheet accompanying the delivery note or on the electronics PC board in the unit
(remove side cover), e.g. "7280024630042
"
- In the case of Compact and chassis-type units, it is on the upper connector strip on the rear of the CUPM basic electronics board, e.g.
"Q6970730324198
"
2) Contact your nearest Siemens branch in order to purchase the PIN number which matches your serial number. Quote the last eight figures of
the serial number.
3) After you have obtained the PIN number, enter it in parameters U977.1 and U977.2.
4) Switch off the power supply to the electronics and then switch it on again.
5) The F01 technology option is now enabled. You can check this by referring to n978.1 = 1 (see above)
Caution: If the PIN-No. U977 is subsequently changed, enabling of the technology is reset (n978 = 0).
PIN number
500h
Special PIN number
V2.5
To Next Page
Loading...
Need help?
General