3 Removing and installing the gearbox
⇒ “3.1 Removing the gearbox”, page 107
⇒ “3.2 Installing the gearbox”, page 132
⇒ “3.3 Tightening torques ”, page 134
⇒ “3.4 Transporting an automatic gearbox”, page 145
⇒ “3.5 Attaching gearbox to assembly stand”, page 145
3.1 Removing the gearbox
⇒ “3.1.1 Remove gearbox Superb II”, page 107
⇒ “3.1.2 Removing gearbox Octavia II”, page 111
⇒ “3.1.3 Removing gearbox Fabia II, Roomster, Rapid”,
page 117
⇒ “3.1.4 Removing gearbox Octavia III”, page 121
⇒ “3.1.5 Removing gearbox (Yeti)”, page 127
3.1.1 Remove gearbox Superb II
Special tools and workshop equipment required
♦ Supporting device - MP9-200 (10-222A)-
♦ Adapter - MP9-200/18 (10-222A/18)-
♦ Support - T10346-
♦ Hook - MP9-200/10-
♦ Engine/gearbox jack - V.A.G 1383A-
♦ Hose clamp - MP7-602 (3094)-
♦ Gearbox mount - 3282-
♦ Adjusting plate - 3282/36-
♦ Wedge - T10161-
Note
♦
If the battery earth strap is disconnected and connected, carry
out additional operations ⇒ Electrical System; Rep. gr. 27 .
♦
All cable straps which are detached or cut open when remov‐
ing, should be fitted on again in the same place when installing.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Shift selector lever into position “P”.
– Remove engine cover ⇒ engine; Rep. gr. 10 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
3. Removing and installing the gearbox 107
ProCarManuals.com