1.6 Removing and installing the slide valve
body
Special tools and workshop equipment required
♦ Protective goggles
WARNING
Do not run the engine or tow the vehicle when the oil pan has
been removed or without ATF filling.
Note
♦
The slide valve body as well as the wiring looms can be re‐
moved even if the gearbox is installed.
♦
Insert gasket rings with ATF. The use of other lubricants leads
to the malfunction of the gearbox hydraulic control system.
♦
Always replace soiled or faulty slide valve bodies.
♦
Do not use fluffy cloths.
♦
⇒ “2 Information and repair instructions for the automatic gear‐
box 09G”, page 12 .
Removing
WARNING
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Removing the oil pan
⇒ “1.4 Removing and installing oil pan”, page 168 .
– Removing oil filter
⇒ “1.5 Removing and installing the oil filter”, page 170 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
1. Removing and installing oil pan, oil filter, slide valve body and internal wiring looms 171
ProCarManuals.com
To Next Page
Loading...
Need help?
General
