Skoda Fabia II 2011 User Manual

– Screw in the support with bolts - VAS 3282/29- into the rear
bore for pendulum support at the gearbox -1-.
– Support the gearbox by carefully raising the engine/gearbox
jack - V.A.G 1383A- .
– Remove the connecting screws for the engine/gearbox
-A-,-B- and then all the remaining connecting screws.
Installation positions of the engine/gearbox screws
⇒ “3.3 Tightening torques ”, page 134 .
Caution
When removing the gearbox, pay attention to the torque con‐
verter.
Prevent it from falling out.
– Push gearbox off engine, simultaneously press the torque
converter against the ATF pump -arrow-.
– Carefully lower the gearbox and guide past the assembly car‐
rier downwards.
Note
Change the gearbox position at the spindles of the gearbox mount
- 3282- when lowering.
– Prevent the torque converter from falling off, e.g. using a wire
-A-.
Note
The depiction of the torque converter and gearbox may vary.
3.2 Installing the gearbox
Installation is carried out in the reverse order. Pay attention to the
following:
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
132 Rep. gr.37 - Controls, housing
ProCarManuals.com

Skoda Fabia II 2011 Specifications

General

Brand	Skoda
Model	Fabia II 2011
Category	Automobile
Language	English