Skoda Fabia II 2011 User Manual

Removing
Caution
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
Touch an earthed object before working on the electrical com‐
ponents. Do not grab directly at the plug contacts or electronic
components.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Unlock the plug connection from the gearbox control unit and
disconnect.
– Press off locking tabs -arrows- from control unit holder.
– Remove control unit from the top.
Note
The adaptation values in the gearbox control unit are reset when
the plug connection is separated. The control unit must re-initial‐
ise these values after the re-connection. During this “initialisation”
the gearshift quality can be worse than usual.
Install
– Insert the control unit into the mounting bracket at the battery
cover until it clicks into the position of the locking tabs
-arrows-.
– Mount the plug connection of the gearbox control unit.
– Connect earth strap of battery ⇒ Electrical System; Rep. gr.
27 .
1.2.3 Removing and installing automatic gear‐
box control unit (YETI) - J217-
Fitting location: The control unit is located at the battery cover in
the engine compartment.
Removing
Caution
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
Touch an earthed object before working on the electrical com‐
ponents. Do not grab directly at the plug contacts or electronic
components.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
1. Electric and electronic components, fitting locations of the automatic gearbox 39
ProCarManuals.com

Skoda Fabia II 2011 Specifications

General

Brand	Skoda
Model	Fabia II 2011
Category	Automobile
Language	English