GTS Technical Manual
5. March 2013 Edition: V1.10/2013 5-49
Copyright © 2013, Diversey Inc.
05.68.10 brush drive - brush belt new setup - 455B_755B eco_755B power_855B power_V1.00.fm
5.9 Brush drive
5.9.4 Mounting of brush belt - New setup
Picture 75: Mount belt - new setup
• Position new belt carefully.
• Mount the small tensioning roller and push it to the limit.
• Tighten the fixation screw of the small tensioning roller.
• Position the tensioning roller on the brush base plate.
• Position the fixation screw and tighten it only as much as
required to move over the brush base plate nozzle.
• Move the tensioning roller with a 17 mm fork spanner over the
nozzle on the brush base plate.
Remarks
If you can not get over the nozzle you can adjust the small tensioning
roller slightly.
• Tighten the fixation screw of the tensioning roller completely.
• Position the cover on the brush drive unit.
• Position and tighten the fixation screws of cover.
Ensure that the belt does not touch the cover.
• Complete assembling according to the chapter MOUNTING OF
BRUSH DRIVE UNIT.
To Next Page
Loading...
Need help?
General