. . . . .
REMOTE INTERFACES
Ethernet Log In/Log Out
TP04300 Series Interface & Applications Manual 4-29
Ethernet Log In/Log Out
Procedure To log in / log out, via Ethernet to a fully booted, operational TP04300A, from a remote host:
Step Action
1 Connect via telnet to 192.168.1.200 (factory default TCP/IP address) port
40957.
2 Terminal type is vt100.
3 Remote host displays:
"Welcome to the X-Stream Server client from [TP04300A IP Address]
###.###.###.### at port ####"
one connection is established.
4 Log in the remote host to control the TP04300A via the ethernet connection. At
the remote host screen, command prompt, type:
LGIN X-Stream.
Press Enter key.
5 Remote host displays:
"Password correct. Controller now is NETWORK"
6 Note: "X-Stream" is the factory installed TP04300A remote login password. If
"X-Stream" does not operate, then the remote login password may have been
changed by a user. (See the LGIN and PASS commands in Chapter 3)
7 The Command Set given in Remote Command Set (page 4-13) can now be
executed from the remote host.
8 The TP04300A screen is slightly "grayed" out, "LOGIN" displays in the
TP04300A screen lower right corner, and in the Status Bar (top of screen), the
"Control" field displays "Network."
9 To disable (exit) remote control, log out by:
1. typing LOUT at the remote command prompt.
2. Press the Enter key.
3. Remote screen displays:
"Success. Controller now is LOCAL."
4. In the Status Bar, the TP04300A screen Control field displays:
"Local."
NOTE: LOUT is required to free the TCP/ IP port of the TP04300A.
To Next Page
Loading...
Need help?
General
