Refrigerant Report
16 CVHE-CLD-1A
Purge Suction Temp/Purge Liquid Temp.
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Purge Pumpout Rate/Purge Max
Pumpout Rate
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Purge Total Pumpout Time/ Purge Total
Run Time
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Purge Adaptive Cycle Time w/Chlr On/
Time to Purge Remaining
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
If the mode selected is not Adaptive, then the time in
the bottom line is dashed out.
Purge Adaptive Cycle Time w/Chlr Off/
Time to Purge Remaining
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
If the mode selected is not Adaptive, then the time in
the bottom line is dashed out.
Purge Service Log
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Pumpout Avg, Last 30 Days
The following screen(s) does not appear if the
selected Purge Control/Type is “Stand-Alone Purge.”
Purge Suction Temp: xxx.x f/c
Purge Liquid Temp: xxx.x f/c
Purge Pumpout Rate: xxx.x Min/24Hrs
Purge Max Pumpout Rate: xx.x Min/24Hrs
Purge Total Pumpout Time: xx,xxx.x Min
Purge Total Run Time: xx,xxx.x Hrs
Purge Adapt Cycle T w/Chlr On: xxx.x Hrs
Time To Purge Remaining: xxx.x Hrs
Purge Adapt Cycle T w/Chlr Off: xxx.x Hrs
Time To Purge Remaining: xxx.x Hrs
Service Log: Reset Log In Field Start_Up
Purge Pumpout Time: xxxxxxx.x Pumpout Min
Service Log: Reset Log In Field Start_Up
Time Since Last Rst: xxxx Cal Days
30 Day Purge Pumpout Avg: xxx.x Min
Chiller Average Run Time: xxx.x Hr/Day
30 Day Pumpout Avg,
Chiller Running: xxx.x Min
Last 5 Cycle Pumpout Avg,Interval From
Shtdn To 3 Hrs After Shtdn: xxx.x Min
30 Day Pumpout Avg, Interval From 3Hrs
After Shtdn To Next Start: xxx.x Min
To Next Page
Loading...
Need help?
General
