Trane CVHG Information Manual

Compressor Report
Information Manual 19
Compressor Phase Currents % RLA
Compressor Line Currents Amps
Compressor Line Voltages
This data is displayed only if the line voltage sensing
option is installed. if not installed, no screen is
displayed.
Compressor Power Factor and Watts
The following is displayed only if the Line Voltage
Sensing Option is Installed AND the starter type is
Not “Adaptive Frequency” or AFD AND Compressor
Power Source is Utility AND External KW is Not
Installed.
Compressor Winding Temperatures
Compressor Starts and Running Time
The starts and hours counters are displayed as
follows:
Bearing Temperatures #1 and #2
The following will be displayed only if the Bearing
Temp Sensors Option is Installed.
Solid State Starter Heat Sink Temp.
The following will be displayed only if the Solid State
Starter is installed.
HGBP Time
If HGBP is installed in the unit the following screen is
displayed:
Compressor Phase Currents - % RLA
A xxxx.x % B xxxx.x % C xxxx.x %
Compressor Phase Currents - Amps
A xxxx amps B xxxx amps C xxxx amps
Compressor Line Voltages
AB xxxx v BC xxxx v CA xxxx v
Compressor Power Factor: xx %
Compressor KiloWatts: xxxx KW
Compressor Winding Temperatures
W1 xxx f/c W2 xxx f/c W3 xxx f/c
Compressor Starts: xxxxx
Compressor Running Time: HRS:MIN:SEC
Bearing Temperature 1: xxx.x f/c
Bearing Temperature 2: xxx.x f/c
Solid State Starter Heat Sink: xxx.x f/c
Press (Next)(Previous) To Continue
HGBP Time: HRS:MIN:SEC
Press (Next)(Previous) To Continue

Trane CVHG Specifications

General

Brand	Trane
Model	CVHG
Category	Chiller
Language	English