To Next Page

To Previous Page

Service Settings (Non Password Protected Service Settings Group)

Information Manual 27

of pressing the <Previous> and <Enter> keys at the

same time.

If the keypad is locked and the password is entered,

the display will go to the Chiller Operating Mode

display of the Chiller Report.

Language Setting

Possible Language Selections for the CLD are:

English (Factory Default), Francais, Deutsche,

Espanol, Nippon (also known as Katakana (uses

Japanese Characters), Italian, Nederland, and

CODED. Possible Language Selections for the

CCCLD are: English (Factory Default), Traditional

Chinese, Simplified Chinese, Korean, Thai, and

Japanese.

Display Units

Possible values of [Type] are: English (Factory

Default) and SI.

Decimal Places Displayed Setpoint

The choices for Status are: XXX.X (Factory Default)

and XXX.

Display Menu Headings Enable

The Factory Default value is Enabled. If disabled the

Menu Headings in each Menu or Group do not

appear.

Clear Custom Menu

When <Enter> is pushed a 2 second message

appears as shown below and then returns to above

screen.

Differential to Start Setpoint

Range of values is 1 to 10°F (0.5 to 5.5°C) in

increments of 1 or 0.1°F or C depending on the

Service Setup Screen xxx or xxx.x. Factory Default is

5°F (2.8°C).

Differential to Stop Setpoint

Range of values is 1 to 10°F (0.5 to 5.5°C) in

increments of 1 or 0.1°F or °C depending on the

Service Setup Screen xxx or xxx.x. Factory Default is

5°F (2.8°C).

******DISPLAY AND KEYPAD ARE LOCKED******

********ENTER PASSWORD TO UNLOCK********

Language: xxxxxxxx