Trane CVHG Information Manual

Refrigerant Monitor Calibration
Information Manual 53
Refrigerant Monitor Calibration
The Refrigerant Monitor Calibration password is - + -
- + + <Enter> for the field calibration menu. If a
refrigerant monitor calibration password is entered,
the display goes to the menu items defined below. If
a key is not pressed every 20 minutes in this
password protected menu, the display returns to the
Chiller Operating Mode display of the Chiller Report,
and a refrigerant monitor calibration password must
be entered again to return to this menu.
Refrigerant Monitor Settings Group
Heading
This header is displayed if the field calibration
password was entered.
This header is displayed if the factory calibration
password was entered.
Refrigerant Monitor Mode
This item is displayed if the Channel Scanner is not
installed.
Refrigerant Zero Calibration
If <Next> is pressed the following refrigerant zero
calibration screens are skipped. If <Enter> is pressed
the following screens are displayed to permit
refrigerant zero calibration.
If the refrigerant monitor is unable to calibrate, the
following item is displayed.
Otherwise, continue with the following screens.
Rfgt Monitor Field Calibration Group
Press (Next)(Previous) To Continue
Rfgt Monitor Factory Calibration Group
Press (Next)(Previous) To Continue
Refrigerant Monitor Mode: [Mode]
Scanner Channel X XXXX PPM [Rfgt Type]
Refrigerant Monitor Mode: [Mode]
XXXX PPM [Rfgt Type]
Refrigerant Zero Calibration
(Enter) to Start, (Next) to Continue
Starting The Calibration Procedure
Please Wait
Unable to Calibrate
Connect Refrigerant Zero Gas
(Next) To Continue, (Cancel) To Exit
Open Gas Sample Valve
(Next) To Continue, (Cancel) To Exit
XXXX PPM [Rfgt Type]
(Enter) To Adjust Conc, (Cancel) to Exit
Locking The Reading
Please Wait

Trane CVHG Specifications

General

Brand	Trane
Model	CVHG
Category	Chiller
Language	English