58
CTV-SVU01G-EN
Security Settings
If security if enabled, the Tracer® AdaptiView™ display requires that you log in with a four-digit
security PIN to make setting changes that are protected by security. This feature prevents
unauthorized personnel from doing so. There are two levels of security, each allowing specific
changes to be made.
You can view all data without logging in. The log-in screen appears only when you try to change
a setting that is protected by security, or when you touch the LLoogg iinn button from the Settings
screen.
Settings Screen
Touch the SSeettttiinnggss button in the main menu area (refer to “Screen Overview,” p. 8) to view the
Settings screen. Security Settings identifies a column on the right side of the screen that contains
two buttons (see the outlined column in the following figure):
• Security
• Log in (Log out)
Figure 35. Equipment Settings screen with the Security Settings column highlighted
NNoottee:: If security is disabled, the Log in/Log out button is not visible. Refer to “Disabling
Security,” p. 58 and “Enabling Security,” p. 59.
Disabling Security
You can disable the security feature that allows a user to log in and log out.
1. From the Settings screen, touch the SSeeccuurriittyy button. The Security screen appears as shown
in the following figure.
NNoottee:: If you are logged out, the Log In screen appears. You must first log in to proceed.
To Next Page
Loading...
Need help?
General
