Trane Tracer AdaptiView User Manual

CTV-SVU01G-EN
83
Table 63. Motor
Active Current Limit Setpoint Phase Unbalance (Ckt1 and Ckt2)
Active Current Limit Setpoint Source Restart Inhibit Time (MP) (Ckt1 and Ckt2)
BAS Current Limit Setpoint Starter Average Phase Voltage (Ckt1 and Ckt2)
External Current Limit Setpoint Starter Current L1 %RLA (Ckt1 and Ckt2)
AFD DC Bus Voltage (Ckt1 and Ckt2) Starter Current L1 (Ckt1 and Ckt2)
AFD Output Power (Ckt1 and Ckt2) Starter Current L2 %RLA (Ckt1 and Ckt2)
AFD Transistor Temperature (Ckt1 and Ckt2) Starter Current L2 (Ckt1 and Ckt2)
Starter Power Consumption (Ckt1 and Ckt2) Starter Current L3 %RLA (Ckt1 and Ckt2)
Starter Load Power Factor (Ckt1 and Ckt2) Starter Current L3 (Ckt1 and Ckt2)
Speed (Ckt1 and Ckt2) Starter Energy Consumption Not Resettable (Ckt1 and Ckt2)
Frequency (Ckt1 and Ckt2) Starter Energy Consumption Resettable (Ckt1 and Ckt2)
Generator Frequency Command (Ckt1 and Ckt2) Starter Energy Consumption Last Reset (Ckt1 and Ckt2)
Generator Speed Signal (Ckt1 and Ckt2) Starter Power Demand (Ckt1 and Ckt2)
Average Line Current %RLA (Ckt1 and Ckt2) Starter Voltage Phase AB (Ckt1 and Ckt2)
Motor Winding Temperature 1 (Ckt1 and Ckt2) Starter Voltage Phase BC (Ckt1 and Ckt2)
Motor Winding Temperature 2 (Ckt1 and Ckt2) Starter Voltage Phase CA (Ckt1 and Ckt2)
Motor Winding Temperature 3 (Ckt1 and Ckt2)
Table 64. Purge
Purge Top Level Mode (Ckt1 and Ckt2) Pumpout—Life (Ckt1 and Ckt2)
Average Daily Pumpout—7 Days (Ckt1 and Ckt2) Purge Carbon Tank Temp (Ckt1 and Ckt2)
Carbon Regen Cycles (Ckt1 and Ckt2) Purge Liquid Temperature (Ckt1 and Ckt2)
Chiller On—7 Days (Ckt1 and Ckt2) Purge Refrigerant Compressor Suction Temp (Ckt1 and Ckt2)
Daily Pumpout—24 Hours (Ckt1 and Ckt2) Time at Last Regeneration (Ckt1 and Ckt2)
Pumpout Chiller Off—7 Days (Ckt1 and Ckt2) Time Until Next Purge Run (Ckt1 and Ckt2)
Pumpout Chiller On—7 Days (Ckt1 and Ckt2)
Data Graph Data Points
This subsection contains:
• Data points used in the default data graphs, organized by graph
• Data points available to include in custom data graphs, organized by component
Data Points Used in Default Data Graphs
Table 65. Chiller Overview 1
Graph data point
Axis
Active Chilled Water Setpoint
Left Y-axis
Active Hot Water Setpoint
Left Y-axis
Evaporator Leaving Evaporator Temperature
Left Y-axis
Evaporator Entering Water Temperature
Left Y-axis
AAppppeennddiixx BB:: DDaattaa ffoorr CCeennTTrraaVVaacc DDuupplleexx CChhiilllleerrss

Trane Tracer AdaptiView Specifications

General

Brand	Trane
Model	Tracer AdaptiView
Category	Monitor
Language	English