32
General Information
The seat can be removed to gain access to
the owner's handbook. An Allen key, located
inside the fuse-box cover, is provided to allow
removal of the seat fasteners.
To remove the fuse cover and locate the
Allen key, gently pull on the lower edge of
the fuse cover to release it from its locating
grommet. Once free of the grommet,
continue to raise the lower edge until the
upper edge can be detached from its locating
slot.
Remove the fixing from the rear of the seat.
Pull the lock release outwards to release the
centre of the seat then raise the seat from the
rear and detach the front edge from the fuel
tank.
To refit, locate the seat to the frame ensuring
the locating tongue is correctly positioned
beneath the fuel tank bridge. Press firmly
down to engage the centre of the seat in the
seat lock.
Finally, tighten the seat retaining screws, store
the Allen key in the space provided and refit
the fuse cover.
Seat - America
Note:
• On America models, under normal
circumstances, it is not necessary
to remove the seat to gain access
to rider-serviceable items.
Stand
Side Stand
1. S i d e s t a n d
The motorcycle is equipped with a side stand
on which the motorcycle can be parked.
Whenever the stand is used, before riding,
always ensure that the stand is fully up after
first sitting on the motorcycle.
For instructions on safe parking, refer to the
'How to Ride the Motorcycle' section.
The motorcycle is fitted with an interlock
system to prevent it from being ridden
with the side stand in the down position.
Never attempt to ride with the side stand
down or interfere with the interlock
mechanism as this will cause a dangerous
riding condition leading to loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
