More functions/services 103
Communicating with PC applications over a
CSTA interface
If configured (contact your service personnel), you can use your phone to com-
municate with PC applications (CSTA = Computer Supported Telecommunica-
tions Applications). You send information to the application and receive informa-
tion from the application, for example, via your phone display.
S Press the "Data I/O" key, key programming page 71.
j Enter the three-digit ID for the application you wish to control.
e, 0...9 Use the TouchGuide and the keypad for communication with the application.
Temporarily interrupting communication with the application
^ The phone is ringing. You answer the call.
T The LED on the "Data I/O" key flashes: Communication to the application is au-
tomatically interrupted.
Resuming communication with the application
T Press the flashing "Data I/O" key. The LED lights up.
Ending communication with the application
Select and confirm the relevant CSTA message.
or
^ \ Lift the handset and replace it again.
Controlling relays (only for HiPath 3000)
If this function has been configured (contact your service personnel), you can
use up to
four relays to enable/disable different devices (such as a door opener).
Depending on how you program the relays, you can activate and deactivate
them manually them or configure them to activate and deactivate automatically
(after timeout).
Select and confirm the option shown,
or
select and confirm the option shown.
1...4 Enter the relay.
Sensors (HiPath 33x0/35x0 only)
If configured (consult your service personnel), sensors are able to recognize sig-
nals, call your phone, and display an appropriate message on the screen.
Special features must be taken into consideration if your telephone oper-
ates with HiPath 5000 (system networking via PC network) page 103!
To Next Page
Loading...
Need help?
General