Enhanced phone functions 61
Transferring a call after a speaker call announcement
in a group
If this function has been configured (contact your service personnel), you can
use a speaker call (announcement,
page 113) to announce a call in progress
to a group of users page 52.
After a member of the group has accepted the call request, you can transfer the
waiting party.
Prerequisite: You are conducting a call.
Confirm. The other party is placed on hold.
v Open the Program/Service menu page 36.
Select and confirm the option shown.
Select and confirm the option shown.
j Enter the group’s station number.
[ Announce the call.
When a member of the group accepts the call page 46, you are connected to
this party.
\ Replace the handset.
or
Select and confirm the option shown
1
.
Sending a trunk flash
To activate ISDN-type services and features through the network carrier’s ana-
log trunks or those of other communications platforms (such as "consultation
hold"), you must send a signal to the trunks before dialing the service code or
telephone number.
Prerequisite: You have set up an external connection.
v Open the Program/Service menu page 36.
Select and confirm the option shown.
Select and confirm the option shown
2
.
j Enter the service code and/or telephone number.
1. ”Differing display view in a HiPath 4000 environment” Seite 144
If the connection between the two other parties is not established within 45
seconds, the call from the first party returns to you (recall).
2. ”Differing display view in a HiPath 4000 environment” Seite 144
To Next Page
Loading...
Need help?
General